Using Device; Selecting A Startup Device; Selecting A Temporary Startup Device - Lenovo K100 Hardware Maintenance Manual

Hardware Maintenance Manual

Using Device

Selecting a startup device

Selecting a temporary startup device

20
Device is used to enable or disable user access to the following device:
Floppy Driver Setup When this feature is set to Disable, the diskette
To set Device, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program"
on page 16).
2. From the Setup Utility program menu, select Device.
3. Select Floppy Driver Setup.
4. Select Onboard Floppy Controller.
5. Select Disable or Enable and press Enter.
6. Return to the Setup Utility program menu and select Exit and then Save
changes and Exit.
Note: If you do not want to save the settings, select Discard Changes
and Exist or Discard Changes. You can set others such as PS/2
Mouse Support, Serial Port Setup, Parallel Port Setup, USB
Setup, ATA Drives Setup, Video Setup, Audio Setup, Network
Setup and so on. See the information displayed on the right side
of the screen.
If your computer does not start up (boot) from a device such as the
CD-ROM, diskette, or hard disk as expected, use one of the following
procedures to select a startup device.
Use this procedure to startup from any boot device.
Note: Not all CDs, hard disks, and diskettes are bootable.
1. Turn off your computer.
2. Press and hold the F12 key then turn on the computer. When the
Startup Device Menu appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu
does not display using this method, repeatedly press and release
the F12 key rather than leaving it pressed when turning on the
computer.
drive cannot be accessed.