Setting Up 3-Connector Sound - Compaq Presario SR1500 - Desktop PC Getting Started Manual

12
Getting Started Guide

Setting up 3-connector sound

PC models that include three sound connectors (select models only) on the back of
the PC support up to six channels of sound (5.1 speaker output) and use the
Multi-channel Sound Manager to configure the software settings.
Connecting the speaker system to the PC (3-connector)
The 3-connector audio speaker system uses the Audio In, Audio Out, and Mic
connectors on the back or front of the PC. Refer to the quick setup poster for the
location of the connectors.
1 With the speaker system off, assemble the speakers and, if used, the subwoofer.
Refer to the speaker documentation.
2 Turn off the PC.
3 Connect the three audio cable plugs from the speaker system to the connectors
on the back of the PC. (See the following table.)
Connect speaker plugs for:
4/4.1
2 Speaker Speaker
Mode Mode
Front Front
speakers speakers
Not used for Rear speakers
speakers
Not used for Not used for
speakers speakers
4 Turn on the PC.
5 Turn on the speaker system.
6 Configure the audio output for this 3-connector multi-channel speaker system by
performing the following procedure.
Configuring the Multi-Channel Sound Manager
(3-connector)
1 Click Start on the taskbar.
2 Choose All Programs.
6/5.1
To PC
Speaker
connector
Mode
Front Audio Out
speakers (lime green)
Rear speakers Audio In
(blue)
Center/ Mic-1 (pink)
subwoofer
speakers
Connector
icon
OUT
IN