Automatic Clean Warning; Rinsing The Iron Steam Chamber - Bosch TDS3520GB Operating Instructions Manual

1
Automatic clean
13
warning
(model dependent)
Pilot light (7*) will flash indicating that
boiler must be rinsed.
To reset the "Calc'n'Clean" counter,
switch the steam station off twice,
keeping it off for at least 30 seconds
each time.
(on → 30s off → on → 30s off → on)
Rinsing the iron
14
steam chamber
Caution! Risk of burns!
This procedure helps to remove scale
particles out of the steam chamber.
This cleaning procedure may be
performed occasionally (approximately
once a year), when after a long period of
use with very hard water, scale particles
start to come out of the soleplate.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (11) of
the iron to the "min" position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set
the main power button (8) to the "I"
position (illuminated in red*).
e) Wait until the "steam ready" indicator
lamp (4) lights up.
f) If the steam station has steam control
(5*), set it to the maximum position
g) Hold the iron over the sink or a
container to collect the water.
h) Press the steam release button
(12) and gently shake the iron.
Boiling water and steam will come
out, carrying scale and or deposits
x2
2
.
that might be there. This could take
approximately 5 minutes.
i) Set the temperature selector (11) of
the iron to the "max" position, without
pressing the steam release button
(12-13*). The water in the steam
chamber will start evaporating. Wait
until all the water inside the chamber
has been evaporated.
j) To clean the soleplate, immediately
rub off any residue by running the
hot iron over dry cotton cloth.
a
c
e
g
i
j
b
d
f
h
5Õ
B OS CH
11