Calc'n'clean Advanced - Bosch Sensixx DS37 Operating Instructions Manual

Calc'n'Clean
11
Advanced
1
a)
0,25 L.
1
Cleaning the Boiler
To extend the life of your steam
generator and to avoid any build up of
scale, it is essential that you rinse out
the boiler after several hours of use
(approximately after 50 hours). If the
water is hard, increase the frequency.
Do not use descaling agents for rinsing
out the boiler, as they could damage it.
~ 2 h.
ºC
2
b)
25 ml
250 ml
x2
2
1. Check carefully that the appliance is
cold and unplugged for more than 2
hours, and that the water tank (1) is
empty.
2. Fix the iron to the stand by inserting
the tip of the iron into the front slot
and moving the fixation lever (11)
against the heel of the iron.
3. Place your appliance on the edge of
your kitchen sink.
4. Unscrew the scale collector (12*) and
take it out.
To wash the scale collector, place
it under the water tap and wash it
up until calc residues are removed.
Squeeze it as indicated in the picture
a). To obtain the best result, you
may immerse the scale collector
for approximately 30 minutes in tap
water (250 ml) mixed with a measure
(25 ml) of descaling fluid, as indicated
in the picture b). Then, rinse it again
with water (very important!).
The descaling fluid can be obtained
from our Aftersales Service or
Specialist outlets:
Accessory code
(After-sales)
00311715
5. Holding your steam generator in
upside down position, and using a
jug, fill the boiler (in the base unit)
with 1/4 litre of water.
6. Shake the base unit for a few
moments and then empty it
completely over a sink or bucket. To
obtain the best result, we recommend
that this operation is done twice.
Important: before re-closing, make
sure no water remains in the boiler.
7. Replace and tighten up the scale
collector.
Name of accessory
(Specialist outlets)
TDZ1101
B OS CH
11