Connecting A Dvd Or Blu-Ray Player - Dynex DX-32L221A12 User Manual

Making connections
Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable to the ANT/CABLE IN jack on the back of
your TV and to the antenna or cable TV wall jack.
Back of TV
3 Turn on your TV.
4 Go through the setup wizard on page 18.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
Coaxial cable
DX-32L221A12/DX-40L260A12

Connecting a DVD or Blu-ray player

Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV's power cord is unplugged and the DVD or
Blu-ray player is turned off.
2 Connect an HDMI cable (not included) to an HDMI jack on the
back of your TV and to the HDMI OUT jack on the DVD or Blu-ray
player.
Back of TV
3 Turn on your TV, then turn on the DVD or Blu-ray player.
4 Press INPUT to open the Input Source list.
5 Press or to highlight HDMI 1 or HDMI 2, then press ENTER.
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
11
DVD or Blu-ray player