Samsung HLS5686WX - 56" Rear Projection TV Owner's Instructions Manual page 37

Setting Up the Remote to Operate Your Set Top Box
1
Turn off your STB.
2
Press the STB button on your TV's remote control.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three
digits of the STB code listed on page 39 of this manual for your
brand of STB. Make sure you enter three digits of the code, even
if the first digit is a "0". (If more than one code is listed, try the
first one.)
5
Press the POWER button on the remote control.
Your STB should turn on if your remote is set up correctly.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of STB.
If no other codes are listed, try each code, 000 through 074.
Note on Using Remote Control Modes: STB
When your remote control is in "STB" mode, the volume buttons still
control your TV's volume
English - 37