Stair Cleaning; How To Clean Tools; Maintenance - Hoover UH70140 Owner's Manual

stair cleaninG

3.4 Lift vacuum by Stair Cleaning Handle and
position on stairs. Clean forward to back. Never
leave the vacuum standing on stairs when not
cleaning.
3.5 Use the Hose and Powered Hand Tool
(Tool varies per model) for stair cleaning. When using
tools, always turn the brushroll off by stepping on the
"Suction Only Mode" pedal (available on select
models only) as shown in diagram 2.3.
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner
from falling, always place cleaner at bottom of stairs on floor. Do not place cleaner on stairs or furniture,
as it may result in injury or damage. When using tools, always turn the brushroll off by
stepping on the "Suction Only Mode" pedal (available on select models only) as shown in diagram 2.3.

how to clean tools

To clean Hose and Powered Hand Tool, wipe with a damp cloth. DO NOT submerge in water.
Other cleaning tools may be washed in warm water with a detergent. Rinse and air dry 24 hours before using.
Familiarize yourself with these home maintenance tasks as proper use and
care of your vacuum will ensure continued cleaning effectiveness.
The System Check Indicator located at (A), alerts you to possible system
performance issues.
probleM
If System Check
Indicator is red:
Any other servicing should be done by an authorized service representative.
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty dirt cup.
3. Inspect and remove blockage along the dirt path. This blockage may occur at the: nozzle inlet,
hose connector, hose, dirt cup inlet, cyclonic filter, Rinsable filter, and HEPA filter.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.
Actual model may vary from images shown.
CAUTION
!

4. Maintenance

possible cause
1. Rinsable filter and/or filter made
with HEPA media is dirty.
2. Dirt cup is full and/or clogged.
3. Brushroll and/or hose is
clogged.
!
3.4
possible solution
1. Clean rinsable filter and/or filter made with
HEPA media - reference pg. 9
2. Empty dirt cup - reference pg. 9
3. Check hose for clogging - reference pg 11.
Check brushroll for clogging - reference pg. 11.
NOTICE
8
3.5
!
4.1
!
A