Download Print this page

Pioneer PWM-6121 Installation Manual

Plasma display mount model
Hide thumbs Also See for PWM-6121:

Advertisement

Quick Links

INSTALLATION MANUAL
PLASMA DISPLAY MOUNT MODEL
For service and parts contact:
Premier Mounts
3130 E. Miraloma Ave
Anaheim, CA USA 92806
Phone: (800) 368-9700 Fax: (800) 832-4888
www.mounts.com
Visit us at:

Advertisement

loading

Summary of Contents for Pioneer PWM-6121

  • Page 1 INSTALLATION MANUAL PLASMA DISPLAY MOUNT MODEL For service and parts contact: Premier Mounts 3130 E. Miraloma Ave Anaheim, CA USA 92806 Phone: (800) 368-9700 Fax: (800) 832-4888 www.mounts.com Visit us at:...
  • Page 2: Table Of Contents

    Contents Safety & precautions Mount diagrams Parts List Installing the mounting bracket Installing the mount Electrical Securing the mounts Additional security - 2 -...
  • Page 3: Safety & Precautions

    Safety & Precautions WARNING: Safety precaution measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the installations procedure to prevent personal injury or damage to the plasma displays or plasma mounts. The wall or ceiling structure must be capable of supporting at least five (5) times the weight of plasma display.
  • Page 4: Mount Diagrams

    Mount Diagrams 19.771 TILT BACK PLATE 16.000 1.250 5.460 1.000 PART#: 2.865 1.125 1.750 3.500 PSB-TBP MATERIAL: 12 (GA) CRS COLOR: Black powder coat 8.000 Lag bolt access slot. 5.000 Mounting points (4.5") used on 18.500 4.500 installations other than wall mounting. Access hole for power or cables.
  • Page 5: Parts List

    Parts List HARDWARE LIST SIZE DESCRIPTION 5/16” Dia Lag bolts Mounting bracket PSB-TBP tilt back plate M6 x 12 (mm) Phillip security Used for additional security on screws tilt mounts, mobile carts, floor stands and ceiling mounts Installations instructions M8 x 20 Phillip screws Mount hardware TOOLS NEEDED Phillips screwdriver...
  • Page 6: Installing The Mounting Bracket

    Installing the mounting bracket WARNING Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display. Step 1 CAUTION : The plasma displays are fragile and heavy.
  • Page 7: Installing The Mount

    Installing the mounts Step 3 CAUTION: The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product. Please verify that your plasma mounting points from the back of the chassis are centered before installing the back plate if not take proper measurements for your installation requirements.
  • Page 8: Electrical

    Once the height is determined, use the bubble level to insure that the bracket is level. Next, using a pencil, mark the six (6) lag bolt slot openings on the mounting bracket. Before continuing, confirm the marks are located on the center of the studs. Drill 1/4" pilot holes on the six (6) markings on the wall. Raise the tilt back plate and have someone hold it in place (arrow side away from the wall and pointing up).
  • Page 9: Securing The Mounts

    Securing the mount Step 5 Warning: The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury. Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing, become familiar with the way the plasma mount attaches to the wall mount.