I/O Device Configuration - Asus ME-99B User Manual

4. BIOS SETUP

4.4.2 I/O Device Configuration

Onboard FDC Controller [Enabled]
When [Enabled], this field allows you to connect your floppy disk drives
to the onboard floppy disk drive connector instead of a separate controller
card. If you want to use a different controller card to connect the floppy
disk drives, set this field to [Disabled]. Configuration options: [Disabled]
[Enabled]
Onboard FDC Swap A & B [No Swap]
This field allows you to reverse the hardware drive letter assignments of
your floppy disk drives. Configuration options: [No Swap] [Swap AB]
Onboard Serial Port 1 [3F8H/IRQ4]
This allows you to set the address for the onboard serial connector. Serial
Port 1 and Serial Port 2 must have different addresses. Configuration op-
tions: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] [Disabled]
Onboard Serial Port 2 [2F8H/IRQ3]
This allows you to set the address for the onboard serial connector. Serial
Port 1 and Serial Port 2 must have different addresses. Configuration op-
tions: [3E8H/IRQ4] [2F8H/IRQ3] [3F8H/IRQ4] [2E8H/IRQ10] [Disabled]
ASUS ME-99B User's Manual 55