Table 5 describes the LED states when the board is powered up and the 10/100 Mbits/sec LAN
subsystem is operating.
Table 5.
LAN Connector LED States
LED Color
LED State
Green
Off
On
Blinking
Yellow
Off
On
1.9.2 LAN Subsystem Software
LAN software and drivers are available from Intel's World Wide Web site.
For information about
Obtaining LAN software and drivers
1.10 Hardware Management Subsystem
The hardware management features enable the Desktop Boards to be compatible with the Wired for
Management (WfM) specification. The Desktop Board has several hardware management features,
including the following:
•
Fan monitoring and control (through the hardware monitoring and fan control ASIC)
•
Thermal and voltage monitoring
•
Chassis intrusion detection
1.10.1 Hardware Monitoring and Fan Control ASIC
The features of the hardware monitoring and fan control ASIC include:
•
Internal ambient temperature sensor
•
Two remote thermal diode sensors for direct monitoring of processor temperature and ambient
temperature sensing
•
Power supply monitoring of five voltages (+5 V, +12 V, +3.3 VSB, +1.5 V, and +VCCP) to
detect levels above or below acceptable values
•
Thermally monitored closed-loop fan control, for all three fans, that can adjust the fan speed or
switch the fans on or off as needed
•
SMBus interface
For information about
The location of the fan connectors and sensors for thermal monitoring
Condition
LAN link is not established.
LAN link is established.
LAN activity is occurring.
10 Mbits/sec data rate is selected.
100 Mbits/sec data rate is selected.
Product Description
Refer to
Section 1.2, page 15
Refer to
Figure 10, page 28
27