Configuring The Wan Setup Options - NETGEAR WNR3500v2 - RangeMax Wireless N Gigabit Router User Manual

NETGEAR RangeMax™ Wireless-N Gigabit Router WNR3500v2 User Manual

Configuring the WAN Setup Options

The WAN Setup screen lets you configure a DMZ (demilitarized zone) server, change the
Maximum Transmit Unit (MTU) size, and enable the wireless router to respond to a ping on the
WAN (Internet) port. From the main menu, under Advanced, click WAN Setup to view the WAN
Setup screen.
Figure 5-3
The WAN Setup fields are described in the following table:
Table 5-2. WAN Setup Settings
Setting
Disable SPI Firewall
Default DMZ Server
Respond to Ping on Internet
WAN Port
Customizing Your Network Settings
Description
The Stateful Packet Inspection (SPI) firewall protects your network and
computers against attacks and intrusions. A stateful packet firewall carefully
inspects incoming traffic packets, looking for known exploits such as
malformed, oversized, or out-of-sequence packets. The firewall should be
disabled only in special circumstances, such as when you are troubleshooting
application issues.
This feature is sometimes helpful when you are using some online games and
videoconferencing. Be careful when using this feature because it makes the
firewall security less effective. See the following section,
DMZ Server.
If you want the wireless router to respond to a ping from the Internet, select
this check box. This should be used only as a diagnostic tool, since it allows
your wireless router to be discovered. Do not select this check box unless you
have a specific reason to do so.
v1.0, May 2009
Setting Up a Default
5-7