Charcoal Filter; Hood Light; Hood Surfaces - GE JV367HWW Owners And Installation Manual

Replaceable charcoal filter
NOTE: DO NOT rinse, or put charcoal
filters in an automatic dishwasher.
When using an energy saving bulb in your GE hood
GE Long Life Energy Smart
or
GE Long Life Energy Smart
Available at www.gelighting.com
The charcoal filter cannot be cleaned.
It must be replaced. Order filter no.
WB02X10700. Replacement filters can be
ordered from your GE supplier.
If the hood is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and
odors.
The charcoal filter should be replaced after 6
to 12 months (depending on hood usage).
Stainless Steel Surfaces
Do not use a steel-wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel cleaner
or polish. Always wipe the surface in the
direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel
surface.
Painted Surfaces
Do not use steel-wool pads or other
abrasive cleaners. They will scratch the
surface.
Clean grease-laden surfaces of the hood
frequently. To clean the hood surface, use
a hot, damp cloth with a mild detergent
suitable for painted surfaces. About one
tablespoon of ammonia may be added to
the water. Use a clean, hot, damp cloth to
remove soap. Dry with a dry, clean cloth.

Hood Light

Light cover
CAUTION:
cool completely before removing. A warm or
hot bulb may break if touched with a moist
cloth or hand.
Remove the bulb and replace it with a type
A15 incandescent light bulb with an ordinary
screw base, not more than 60 Watts, or a
type A17 or T2 Compact Fluorescent (CFL)
Spiral T2
™ ®
light bulb with an ordinary screw base,
not more than 13 Watts. NOTE: Use only
incandescent bulbs in models RN328, JN327
and JV338.
IMPORTANT: For installation, handling and
disposal precautions, refer to the fluorescent
bulb packaging literature.
A17
™
To remove:
Pull down on the center of the front edge
of the filter. The filter will then slip out of the
retaining tabs on the back.
To replace:
Slip the back edge of the filter into the
retaining tabs and push the front edge up
until it snaps into place.
(on some models)
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
National Parts Center
GEApplianceParts.com
(on some models)
NOTE: When cleaning, take care not to
come in contact with filters and other non-
enameled surfaces.
hood surfaces, be certain that you do not
touch the light bulb with moist hands or
cloth. A warm or hot light bulb may break if
touched with a moist surface. Always let the
light bulb cool completely before cleaning
around it.
To remove the light cover
Let the light bulb
(on some models):
• Press the sides with two fingers until the
side prongs are released.
• Lift the light cover and slide it toward you
in one motion.
To replace the light cover:
• Insert the prong located at the end of the
cover into the top opening.
• Gently push the cover up and press the
sides to fit the side prongs into the side
openings.
• Release and the cover will lock in position.
800.626.2002
CAUTION:
When cleaning the
5