Allied Telesis AT-WCP200G User Manual page 30

If the SSID parameter is "ANY," it will detect the strongest signal of
the wireless station.
Channel
It shows radio channel numbers that are used for Wireless LAN
networking.
The channel number can be set only under the Ad-Hoc operation
mode. In Ad-Hoc mode, each station must have the same channel
numbers and SSID.
In Infrastructure mode, the AT-WCP200G adapter will
automatically detect the channel number of the access point.
Under Security you can set:
Network Encryption
This function is used to protect wireless communication from
eavesdropping. A secondary function of encryption is to prevent
unauthorized access to a wireless network, and it can be achieved
by using the Encryption function.
Check the Enable Encryption box to activate the security of the
PCI Adapter.
Key 1 - 4:
You can type the key that you want to use from Key 1 to Key 4. The
key that you type will be the encryption between the station that
you are connected with.
If you select 64-bit in Hex format, you must type 10 values in the
following range (0 - F, hexadecimal), or 64-bit in ASCII format, you
must type 5 values in the following range (0 - 9, A - Z, and a - z
Alphanumeric).
If you select 128-bit in Hex format, you must type 26 values (0 - F,
hexadecimal), or 128-bit in ASCII format, you must type 13 values
in the following range (0 - 9, A - Z and a - z Alphanumeric).
If you select 256-bit in Hex format, you must type 58 values (0 - F,
hexadecimal), or 256-bit in ASCII format, you must type 29 values
in the following range (0 - 9, A - Z and a - z Alphanumeric).
Be sure that the PCI Adapter and the wireless station is set in the
same key.
Create with Passphrase
The Passphrase helps you create a group of WEP key in the Key
Setting. If you input a phrase in the Create with Passphrase field,
the group of key setting will be changed.
30