Oki ML690 User Manual page 63

MENU SETTINGS TABLE
Group Item
Set-Up Sleep Mode
(cont.)
Sleep Time
Pin Control
Pin Control Select
Paper End
FF Function
Function
Default setting saves power by
having the printer go into sleep
mode; when disabled the printer
never goes into sleep mode.
Set the idle time before the printer
enters sleep mode (when Sleep
Mode is enabled).
Regulates the striking force for
multi-part forms. For single
sheets, use "Standard"; for multi-
part forms, use "Special."
Regulates the striking force for
multi-part forms. For single
sheets, use "Mode1"; for multi-
part forms, use "Mode2."
In default setting when paper end
is detected, printer remains on-
line; if set to Off-line, when paper
end is detected, printer goes off-
line.
Set the feeding operation upon
receiving an FF code after cut
sheet paper is fed.
Settings (defaults are set in bold italic)
Enable, Disable
5 min, 10 min, 15 min, 30 min, 60
min
Standard, Special
Mode1, Mode2
On-line, Off-line
Eject, Form Feed
ML690/ML691 User's Guide