Advertisement
Step 2:
If you do not create RAID, select Hard Disk Boot Priority under the Advanced BIOS Features menu.
In the Hard Disk Boot Priority submenu, select the model of the SATA hard drive onto which you wish
to install Microsoft Windows 2000/XP. You should see a screen similar to Figure 2 below.
1. CH2 M.
:
2. CH3 M.
:
3. Bootable Add-in Cards
hi: Move
PU/PD/+/-: Change Priority
If you wish to create RAID, configure the RAID array in RAID BIOS (refer to page 6) first. After finished,
re-enter the system BIOS Setup to set hard disk boot priority before OS installation. Select Hard Disk
Boot Priority under the Advanced BIOS Features menu. In the Hard Disk Boot Priority submenu,
select the RAID array onto which you wish to install Microsoft Windows 2000/XP. You should see a
screen similar to Figure 3 below.
1. SCSI-0:
NVIDIA MIRROR 111.78G
2. Bootable Add-in Cards
hi: Move
PU/PD/+/-: Change Priority
SATA Hard Drive Configurations (nForce series) - 4 -
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
S_ATA1-ST3120026AS
S_ATA2-ST3120026AS
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
F10: Save
Figure 2
F10: Save
Figure 3
Item Help
}}
Menu Level
Use <h>
or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit
Item Help
}}
Menu Level
Use <h>
or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit
Advertisement
