Advertisement
After that, the Array List screen displaying the RAID array you created will appear (Figure 10).
If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array
and press B. The Boot section will show Yes.
[Ctrl-X] Exit
To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure
11), where you should see detailed information about RAID mode, disk block size, disk model name,
and disk capacity, etc.
RAID Mode: Striping
Striping Width : 2
Adapt
2
2
To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears,
press Y to confirm or N to cancel. Press ENTER to return to the Array List screen.
To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen.
Now, you can proceed to install the SATA controller driver and operating system.
SATA Configurations (P4 nForce4 SLI series)
MediaShield RAID Utility Feb 8 2005
Boot
Id
Status
No
2
Healthy
[h i ] Select
[B] Set Boot
Array 2 : NVIDIA STRIPE 223.58G
Channel
M/S
0
Master
1
Master
[R] Rebuild
[D] Delete
- Array List -
Vendor
Array Model Name
NVIDIA
STRIPE 223.58G
[N] New Array
Figure 10
- Array Detail -
Striping Block: 64K
Index
Disk Model Name
0
ST3120026AS
1
ST3120026AS
[C] Clear Disk
[ENTER] Return
Figure 11
- 8 -
[ENTER] Detail
Capacity
111.79GB
111.79GB
Advertisement
