Advertisement
Step 2:
If you do not create RAID, select Hard Disk Boot Priority under the Advanced BIOS Features menu.
In the Hard Disk Boot Priority submenu, select the model of the SATA hard drive onto which you wish
to install Microsoft Windows 2000/XP. You should see a screen similar to Figure 3 below.
1. CH2 M.
:
2. CH3 M.
:
3. Bootable Add-in Cards
hi: Move
PU/PD/+/-: Change Priority
After configuring the SATA controller mode in system BIOS, if you wish to create RAID, save the settings
and exit. Then go to RAID BIOS (refer to page 6) to configure the RAID array. After finished, re-enter the
system BIOS Setup to set hard disk boot priority before OS installation. Select Hard Disk Boot Priority
under the Advanced BIOS Features menu. In the Hard Disk Boot Priority submenu, select the RAID
array onto which you wish to install Microsoft Windows 2000/XP (Figure 4).
1. SCSI-0:
NVIDIA MIRROR 111.7
2. Bootable Add-in Cards
hi: Move
PU/PD/+/-: Change Priority
SATA Configurations (P4 nForce4 SLI series)
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
ST3120026AS
ST3120026AS
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Hard Disk Boot Priority
Figure 4
F10: Save
Figure 3
F10: Save
- 4 -
Item Help
}}
Menu Level
Use <h>
or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit
Item Help
}}
Menu Level
Use <h>
or <i> to
select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
menu.
ESC: Exit
Advertisement
