Eiki LC-XNB5M Owner's Manual page 35

Power management
This function turns the Projection Lamp off when this projector
detects signal interruption and is not used for a certain period in
order to reduce power consumption and maintain the Lamp-life.
(This projector is shipped with this function ON.)
The Power Management function operates to turn the Projection
Lamp off when the input signal is interrupted and any button is not
pressed over 5 minutes. This function operates as follows;
1. When any input signal is interrupted, "No signal" and the
counting down display appears (for 5 minutes).
2. After counting down for 5 minutes, the Projection Lamp and the
READY Indicator are turned off. (Cooling Fans keep running.)
3. The READY Indicator starts to flash after cooling down the
Projection Lamp about for 90 seconds (Power Management
mode).
In this Power Management mode, the Projection Lamp is
automatically turned on when the input signal is connected or
the projector is operated with any button on the Top Control or
on the Remote Control again.
On start
When this function is "On," the projector is automatically turned on
just by connecting the AC Power cord to a wall outlet.
Note ; Be sure to turn the projector off properly (refer to the section
"TURNING OFF PROJECTOR" on page 19). If the projector
is turned off in the wrong steps, the On Start function does not
operate properly.
Lamp mode
When selecting the " " (Eco), the projector reduce the brightness
and set into the low power consumption mode.
Remote control
This projector has two different remote control codes; the factory-set
normal code (Code 1) and the secondary code (Code 2). This
switching function prevents remote control operation mixture (jam)
when operating several projectors or video equipment together.
When operating the projector in "Code 2," both the projector and the
Remote Control must be switched to "Code 2."
To change the code of the Projector;
Set the Remote control in the SETTING MENU to "Code 2."
To change the code of the Remote Control;
Press both the MENU and the IMAGE buttons on the Remote
Control together for over 10 seconds.
After changing the code, make sure the Remote Control operates
properly.
To return to the initial code (Code 1), repeat the steps above.
NOTE : When the batteries of the Remote Control are replaced or
ALL-OFF switch is turned to "ALL-OFF," the remote control
code automatically returns to the normal code (Code 1).
Lamp counter reset
This function is used to reset the Lamp Replace Counter. When
replacing the Projection Lamp, reset the Lamp Replace Counter by
using this function. Refer to page 37 for operation.
SETTING
Time left until Lamp off.
Press the SELECT button at this
icon to display other items.
Press the SELECT button at this
icon to display previous items.
Move the pointer to the item and
then press the POINT
LEFT/RIGHT button(s).
35