Table of Contents
Advertisement
Connect the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate
terminals on the rear of the projector. (See "CONNECTING THE PROJECTOR" section on pages 11-18).
Connect the projector's AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the rear
of the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will
light GREEN.
Press the POWER ON/OFF button on the remote control unit or on the projector to
ON. The LAMP POWER indicator light will dim and the cooling fans will operate.
The wait display appears on the screen and the count-down starts (30-29-28-...1).
The signal from the source appears after 30 seconds.
CAUTION:
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES
BEFORE TURNING IT OFF.
NOTE:
TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off. Wait at least 5 minutes
before turning the projector on.
If the TEMPERATURE WARNING INDICATOR continued to flash, follow the procedures below:
(1). Press POWER ON/OFF button to OFF.
(2). Check the air filter for dust accumulation.
(3). Remove dust with vacuum cleaner. (See "AIR FILTER CARE AND CLEANING" section on page 49).
(4). Press POWER ON/OFF button to ON.
If the TEMPERATURE WARNING INDICATOR still continues to flash, call your authorized dealer or service
station.
Press the POWER ON/OFF button on the remote control unit or on the
projector.
The "Power off
button to turn OFF the projector. The LAMP POWER indicator will light bright and
READY indicator will turn off. The cooling fans will operate for approximate 2 minutes
after the projector is turned off. (During this "cooling down" period, the projector cannot
turned on). The READY indicator will light green again and the projector
be
may be turned on by pressing the POWER ON/OFF button. To power down
completely, turn the MAIN ON/OFF switch (located on the rear of the
projector) to the OFF position.
Press the MODE button on the projector or the
COMPUTER and VIDEO button on the remote control unit
to select Computer 1, Computer 2, Video Input. The
"Computer 1", "Computer 2" or "Video" display will appear
on the screen for a few seconds
appears on the screen. Press again the POWER ON/OFF
?"
.
Advertisement
Table of Contents
