Wall Mounting - JBL SCS 260.5 Owner's Manual

WALL-MOUNTING
Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speakers,
and for proper assembly and
installation of the wall-brack-
ets, including but not limited
to the selection of appropri-
ate weight-bearing supports
and proper use of the
bracket. JBL disclaims any
liability for the selection of
mounting hardware and/or
bracket installation. Be sure
to follow these bracket
assembly and installation
instructions carefully. If you
have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.
Step 1: Unscrew and remove
the large Molded Nut
necessary, use the supplied
∞
Metal Bar as a lever by
inserting it into one of the
holes in the outer edge of the
™
Molded Nut .
Step 2: Firmly grasp the Ball
£
and Shaft and pull it
straight out of the Attach-
¢
ment Plate . Avoid leaning
it to the side for leverage, as
this may break off a tab.
4
3
8
5
Step 3: Slide the Molded Nut
™
onto the Ball and Shaft
£
with the threaded open-
ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,
with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
three parts.
™
. If
Step 4: Screw the Ball and
Shaft
Insert
Satellite Speaker
is fully seated in the
Threaded Insert
not tighten as you might dis-
lodge the Threaded Insert
§. Such damage would
not be covered under the
warranty.
2
1
£ into the Threaded
§
on the back of the
¶
until it
§
, but do
Step 5: Tighten the Metal Nut
¡
with the star washer side
between the Metal Nut
and the back of the Satellite
¶
Speaker , using large
needle-nose pliers until it is
firmly seated against the
back of the Speaker
has locked the Ball and
£
Shaft and the Speaker
together.
Note that once the Metal
¡
Nut is fully tightened, it
may embed some marks on
the back of the Satellite
¶
Speaker . However, these
marks will be covered by the
¡
Metal Nut .
Step 6: Mount the Attach-
¢
ment Plate
stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
•
supplied) . Make sure that
7
6
1
2
3
5
8
all four screws are driven
into the stud and not into dry-
wall. If the bracket needs to
be mounted in drywall, the
customer is responsible for
selecting and using appro-
priate wall-anchors and
screws.
Important Note: The Metal
¡
Nut must be fully tight-
ened against the Satellite
Speaker ¶ as described in
¡
¶
and
¶
into a wood
4
7