Surround Channels; Center Channel - Infinity Total Solutions TSS-800 Owner's Manual

Hide thumbs Also See for Total Solutions TSS-800:
Table of Contents

Advertisement

P
LACEMENT
Left and Right Front Channels
For left and right front channels, place one satellite to the left
and another to the right of the television, as shown in Figure 1.
Since the speakers are magnetically shielded, you can place
them very close to the TV without worrying about the magnetic
field distorting the picture.

Center Channel

For the center channel, place the speaker directly on top of,
or below, your television. Use a shelf or one of the included wall
brackets if the television does not provide a stable platform.

Surround Channels

For left and right surround channels, place one speaker on the
left and another on the right, to the side of or slightly behind the
listening area.The surround speakers should be mounted at a
height of between 5 ft. (1.5m) and 7 ft. (2m).
Subwoofer
Since the installation of a subwoofer can be somewhat more
complicated than installing full-range speakers, it is essential
that you read this section very carefully prior to connecting the
subwoofer to your system. Should you have questions relating to
installation, it is advisable to call either your dealer or Infinity's
Customer Service Department for advice.
The performance of the subwoofer is directly related to its
placement in the listening room and how you align the subwoofer
with the satellite speakers. Setting the volume of the subwoofer
in relation to the left and right speakers is also of critical
importance because it is essential that the subwoofer integrate
smoothly with the entire system. Setting the subwoofer's volume
level too high will result in an overpowering, boomy bass. Setting
the volume level too low will negate the benefits of the subwoofer.
Here are several additional facts on installation that may prove
useful. It is generally believed that low frequencies (below
125Hz) are nondirectional and, therefore, placement of a
subwoofer within any listening room is not critical. While in
theory it is true that the larger wavelengths of extremely low
frequencies are basically nondirectional, the fact is that, when
installing a subwoofer within the limited confines of a room,
reflections, standing waves and absorptions generated within the
room will strongly influence the performance of any subwoofer
system. As a result, specific location of the subwoofer becomes
important, and we strongly recommend that you experiment with
placement before choosing a final location. Placement will
depend upon your room (for example, whether or not your room
permits placement of the subwoofer near either satellite) and
the amount and quality of bass required.
Using the Satellite on the Shelf Stand
To attach the satellite to the shelf stand, hold the satellite on top
of the stand and insert the two included screws through the rear
of the stand and into the rear of the speaker.
®
W
-M
ALL
OUNTING THE
C
C
ENTER
HANNEL
The TSS-800 satellites and center channel are designed to be
mounted on the wall.There is a fixed-mount wall bracket and an
adjustable wall bracket provided for each satellite and the center
channel. Each speaker bracket will require up to four 1-1/2" #10
®
wood screws; each screw should be fastened to a wall stud. If a
wall stud is unavailable, install an anchor appropriate for a 1-1/2"
#10 screw.
NOTE: The customer is responsible for the correct selection
and use of mounting hardware (available through hardware
stores) that will ensure the proper and safe wall-mounting of
the speakers.
Fixed-Mount Wall Bracket
Step 1. Mark the positions on the wall where you would like to
place the mounting screws.
Step 2. Attach the back plate of the bracket to the wall using
three screws (not included).
Step 3. Attach the front plate (with the spring tab) of the bracket
to the satellite or center channel
using the two provided screws.
Step 4. Slide the satellite or center
channel speaker with
attached bracket front plate
onto the back plate of the
bracket until the tab locks
into place.
To remove speaker from
the wall, simply push in
the locking tab and slide
the speaker up.
keyhole on the back of the speaker to the
screwhead on the wall. Once positioned properly, the speaker
should slide down slightly and become secure.
®
S
ATELLITES AND
TSS-800 (120V)
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tss-800

Table of Contents