Getting Started; Battery Installation; Battery Notice - VTech SmartVille - Musical Band Stand User Manual

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a coin or screwdriver
to loosen the screw.
3. Install 2 new "AA" size (UM3/LR6)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten
the screw to secure the battery cover.

BATTERY NOTICE

• Install batteries correctly observing the polarity (+, -) signs to avoid
leakage.
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Remove batteries from the equipment when the unit will not be
used for an extended for an extended period of time.
• Always remove exhausted batteries from the equipment.
• Do not dispose of battery in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended
are to be used.
WE DO NOT RECOMMEND THE USE OF RECHARGEABLE
BATTERIES.
4