Asus M4A77TD - Motherboard - ATX User Manual page 35

3. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4, SATA5, and SATA6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133MB/s (Ultra DMA133). If you install Serial ATA hard disk
drives, you can create a RAID 0, RAID 1, or RAID 0+1 set through the onboard SB710
chipset.
M4A77TD
M4A77TD SATA connectors
• Install the Windows
• If you intend to create a SATA RAID set, set the type of the SATA connectors to [RAID]
in the BIOS. See 2.3.4 SATA Configuration for details.
• The motherboard does not provide a floppy disk drive connector. You could use a USB
floppy disk drive when installing Windows
that includes a RAID/AHCI set.
• Due to Windows
drive.
• For more details on RAID/AHCI, refer to the RA ID/AHCI Supplementary Guide included
in the folder named Manual in the support DVD.
ASUS M4A77TD
SATA1 SATA2
SATA4 SATA5
XP Service Pack 1 or later versions before using Serial ATA.
®
XP limitation, Windows
®
SATA3
SATA6
XP operating system on a hard disk drive
®
XP may not recognize the USB floppy disk
®
1-23