USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
The USB 2.0 module is purchased separately.
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports the AC`97 audio standard. Connect one end of the front panel audio
I/O module cable to this connector.
M2V-MX.SE.Front Panel Audio Connector
We recommend that you connect a high-definition front panel audio module
to this connector to avail of the motherboard's high-definition audio capability.
By default, this connector is set to HD Audio. If you want to connect a
AC'97 front panel audio module to this connector, set the Front.Panel.
Support Type item in the BIOS setup to [AC97]. See SouthBridge VIA
VT8237S Configuration in.section 2.4.3 Chipset.
Chapter 1: Product introduction