2.
USB device wake-up (3-pin PS2_USBPW1-4, USBPW5-8, USBPW9-12)
Set these jumpers to +5V to wake up the computer from S1 sleep mode
(CPU stopped, DRAM refreshed, system running in low power mode) using
the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep
modes.
The USBPW1-4 jumpers are for the rear USB ports. The USBPW5-8 and
USBPW910 jumpers are for the internal USB connectors that you can
connect to additional USB ports.
•
•
3.
HDJ1 Setting
This jumper allows you to switch between the HDMI and the DVI features.
Set this jumper to pins 1-2 (HDMI) to enable the HDMI feature. Set this
jumper to pins 2-3 to enable the DVI feature.
1-24
R
M2N-VM SE HDMI
The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port. Otherwise,
the system will not power up.
The total current consumed must NOT exceed the power supply
capability (+5VSB) whether under normal condition or in sleep mode.
R
M2N-VM SE HDMI
(Default)
Chapter 1: Product introduction