Security - Asus M2A VM - Motherboard - Micro ATX User Manual

2.6.5

Security

Supervisor Password
User Password
Password Check
Supervisor Password
. User.Password
These fields allow you to set passwords:
To set a password:
1. Select an item then press <Enter>.
2. Type in a password using a combination of a maximum of eight (8) alpha-
numeric characters, then press <Enter>.
3. When prompted, confirm the password by typing the exact characters again,
then press <Enter>. The password field setting is changed to Set.
To clear the password:
1. Select the password field and press <Enter> twice. The following message
appears:
PASSWORD DISABLED !!!
Press any key to continue...
2. Press any key to continue. The password field setting is changed to Clear.
A note about passwords
The Supervisor password is required to enter the BIOS Setup program
preventing unauthorized access. The User password is required to boot the
system preventing unauthorized use.
Forgot your password?
If you forget your password, you can clear it by erasing the CMOS Real Time
Clock (RTC) RAM. The RAM data containing the password information is
powered by the onboard button cell battery. If you need to erase the CMOS
RAM, refer to section "1.9 Jumpers" for instructions.
Password.Check
This field requires you to enter the password before entering the BIOS setup or the
system. Select [Setup] to require the password before entering the BIOS Setup.
Select [System] to require the password before entering the system. Configuration
options: [Setup] [System]
2-34
Phoenix-Award BIOS CMOS Setup Utility
Boot
Security
Clear
Clear
[Setup]
Select Menu
Item Specific Help
Chapter 2: BIOS setup