Onboard Device Configuration - Asus M2A VM - Motherboard - Micro ATX User Manual

IRQ Resources
This sub-menu is activated only when the Resources Controlled By item is set to
[Manual].
Advanced
IRQ Resources
IRQ-3 assigned to
IRQ-4 assigned to
IRQ-5 assigned to
IRQ-7 assigned to
IRQ-10 assigned to
IRQ-11 assigned to
IRQ-14 assigned to
IRQ-15 assigned to
IRQ Resources
When set to [PCI Device], the specific IRQ is free for use of PCI/PnP
devices. When set to [Reserved], the IRQ is reserved for legacy ISA devices.
Configuration options: [PCI Device] [Reserved]
PCI.Latenct.Timer.(CLK).[64]
Use <+> and <-> to adjust the value. The value ranges from 0 to 255.
Maximum Payload Size [4096]
Sets maximum TLP payload size for the PCI Express devices. The unit is byte.
Configuration options: [128] [256] [512] [1024] [2048] [4096]
2.4.4

Onboard Device Configuration

Advanced
South OnChip IDE Device
South OnChip PCI Device
Front Panel Type
Primary Display Adapter
Onboard LAN
Onboard LAN Boot ROM
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
x ECP Mode Use DMA
F1:Help
ESC: Exit
2-24
Phoenix-Award BIOS CMOS Setup Utility
Phoenix-Award BIOS CMOS Setup Utility
Onboard Device Configuration
↑↓ : Select Item
→←: Select Menu
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[HD Audio]
[PCIEx]
[Enabled]
[Disabled]
[3F8/IRQ4]
[378/IRQ7]
[EPP]
3
-/+: Change Value
Enter: Select SubMenu
Select Menu
Item Specific Help
Legacy ISA for devices
compliant with the
original PC AT bus
specification, PCI/ISA PnP
for devices compliant with
Select Menu
Item Specific Help
F5: Setup Defaults
F10: Save and Exit
Chapter 2: BIOS setup