Keyboard Status Leds; Installing 3 Or More Devices - Gyration GP110-001 User Manual

synchronized device is transmitting. If there is radio interference, the flickering light will be
inconsistent.
The Status LED blinks slowly (1 blink per second) when the receiver is in Learn Mode and is
T
awaiting a Teach instruction from a device.
T The Status LED blinks rapidly for a 4-second burst when it is in Learn Mode and processing a Teach
instruction and synchronizing the receiver with the device.

Keyboard Status LEDs

The Keyboard Status LEDs will indicate whether your computer has the Num Lock, Caps Lock and/or Scroll
Lock features activated.
Conflict LED
If an unrecognized Gyration device is attempting to operate on the same channel as a device that has been
synchronized, the red "Conflict" LED on the receiver will flicker and input control may be intermittent.
The Conflict Light will only detect interference from another Gyration RF device (i.e. not cordless phones,
personal radios, etc.).

Installing 3 or More Devices

The Receiver can be taught to recognize up to eight devices (mice, remotes, keyboards, etc.) on a system,
but only two of those devices may be used simultaneously. When setting up a system with a single receiver
and 3 or more devices, the following guidelines must be followed:
Select two channels that are free of outside interference and install all devices on either of those
T
two channels. When possible, it is recommended that the two chosen channels be separated by at
least one unused channel.
Any of the devices installed on one channel may be used simultaneously with any of the devices on
T
the other channel. Two devices that share a channel may not be used simultaneously. When
installing the devices try to determine which devices will be used simultaneously and set them on
opposite channels.
The following example describes a single-receiver system with two mice and a keyboard that requires one
mouse to be used by a presenter for cursor control while another presenter inputs data on the keyboard.
Mouse #1 is set to channel 3 and the keyboard and mouse #2 are set to channel 5. With this configuration,
mouse #1 and the keyboard can be used simultaneously, but mouse #2 and the keyboard cannot.
Note: Gyration carries both a consumer and professional line of RF products. Please note that a low-power consumer
device (i.e. Ultra mouse with 25-ft. range) should not be used simultaneously with a high-power professional device (i.e.
RF Keyboard with 100-ft. range). One or both devices may not work properly if data is being transmitted by the two units
at the same time. For optimal simultaneous performance, it is recommended that you use two low-powered devices or two
high-powered devices. If you wish to use both a high- and low-power device simultaneously, it is recommended that you
alternate usage between the devices.
8