Sony Handycam NEX-VG30 Operating Manual page 68

Do not damage the power cord (mains lead)

such as by placing anything heavy on it.
Do not use a deformed or damaged battery

pack.
Keep metal contacts clean.

If the battery electrolytic liquid has leaked:

Consult your local authorized Sony service

facility.
Wash off any liquid that may have contacted

your skin.
If any liquid gets in your eyes, wash with

plenty of water and consult a doctor.
When not using your camcorder for a
long time
To keep your camcorder in optimum state for a

long time, turn it on and let it run by recording
and playing back images about once a month.
Use up the battery pack completely before

storing it.
LCD screen
Do not exert excessive pressure on the LCD

screen, as it may cause damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
If hand grease or hand cream remains on the

screen, the coating comes off more easily. Wipe
it early.
The coating may be scratched if you wipe the

screen with a tissue, etc.
If fingerprints and dust get on the screen, it is

recommended that you first remove the dust
with a blower, etc., then use a soft cloth to
remove the fingerprints.
On handling the casing
If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
US

Avoid the following to avoid damage to the

finish:
Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent, insecticide
and sunscreen
Handling the camcorder with above

substances on your hands
Leaving the casing in contact with rubber or

vinyl objects for a long period of time
About care and storage of the lens
Wipe the surface of the lens clean with a soft

cloth in the following instances:
When there are fingerprints on the lens

surface
In hot or humid locations

When the lens is exposed to salty air such as

at the seaside
Store in a well-ventilated location subject to

little dirt or dust.
To prevent mold, periodically clean the lens as

described above.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed rechargeable
battery to retain the date, time, and other settings
even when the camcorder is turned off. The pre-
installed rechargeable battery is always charged
while your camcorder is connected to the wall
outlet (wall socket) via the AC Adaptor or while
the battery pack is attached. The rechargeable
battery will be fully discharged in about 3 months
if you do not use your camcorder at all. Use
your camcorder after charging the pre-installed
rechargeable battery. However, even if the pre-
installed rechargeable battery is not charged, the
camcorder operation will not be affected as long
as you are not recording the date.
Procedures
Connect your camcorder to a wall outlet (wall
socket) using the supplied AC Adaptor, and leave
it for more than 24 hours.