Cable Requirement - 3Com 3CRWX395075A - Wireless LAN Managed Access Point 3950 Quick Installation Manual

Cable Requirement

The Ethernet ports on the access point cannot accept a Category 5 cable that has an uneven sheath
such as the one shown in the figure below. The RJ-45 connector on the cable will not seat properly in
the receptacle on the access point. Use a Category 5 cable with an even sheath instead.
Uneven sheath
Suspended Ceiling — Flush Ceiling Tiles
This procedure applies to T-bars that are 23.9 mm (15/16 inches) wide. For a 14.2-mm (9/16-inch) or
15.9-mm (5/8-inch) T-bar, go to "Suspended Ceiling Installation — Drop Ceiling Tiles" on page 8.
Mobility
AP3950 access point
point
Use the mounting template to cut a hole for the Category 5 cable.
1
Remove the mounting bracket from the access point.
2
Mounting
Mounting template
template
6
Mounting
Mounting bracket
bracket