Table of Contents
Advertisement
Grounding Point
Integrated Antenna
Observing Safety Precautions
This equipment must be installed in compliance with local and national building codes, regulatory
restrictions, and FCC rules. For the safety of people and equipment, only professional network personnel
should install the bridge.
To comply with FCC radio frequency (RF) exposure limits, a minimum body-to-
WARNING:
antenna distance of 20 cm (8 in.) must be maintained when the bridge is operational.
WARNING: To avoid possible injury or damage to equipment, you must use power supply equipment
that is safety certified according to UL, CSA, IEC, or other applicable national or international safety
requirements for the country of use. All references to power supply in this document refer to equipment
meeting these requirements.
1
Unpacking the Bridge
Make sure that you have the following items, which are included in the package:
•
One 3Com Outdoor 11a Building to Building Bridge and 11bg Access Point
•
Mounting bracket and hardware
•
One Weatherproof Category 5 network cable
•
One Weatherproof Console to RS232 cable
•
PoE power injector/ Ethernet connector and AC power cord
•
One grounding screw, not attached
•
This Quick Start Guide
•
One CD-ROM containing the Setup Wizard software and User's Manual
•
One Warranty Flyer
•
Optional: One N-type RF coaxial cable
2
Preparing for Installation
It is advisable to connect and check the PoE connection, Ethernet cables, and LEDs before installing the
bridge in a hard-to-reach location. Additionally, observe the following items before mounting or
connecting the bridge:
Installation Item
Cabling
Power Requirements
In the event of electrostatic shock the connection of an insulated cable to the
grounding point to an earthed point protects the unit from excessive electrical
discharge. A grounding screw is provided in the package contents.
Built in 5.0 GHz flat panel high-gain antenna.
Description
Make sure that standard Category 5e cable with straight-through signaling is
installed at the site before you install the bridge.
Power should be supplied via the 3Com proprietary POE injector.
3
Advertisement
Table of Contents
