Yamaha RS-80 Assembly Instructions page 2

I RS-80 Assembly
* A screw driver (+ or -) is necessary to complete the assembly.
Over-tightening of the fixing bolts may result in damage.
Take care when tightening fixing bolts and screws.
Insert the Right Side Assembly
1
and tighten the fixing bolts.
Insert the Left Side Assembly
2
pipe into the Center Bar
C
Make sure that the Left and Right Side Assemblies are not reversed.
Above the Center Bar
3
the fixing bolts.
Tighten
Tighten
Center Bar
E
Left Side Assembly
A
Attach the Module Holder
4
4-1 Insert the Hex Rod Cylinder
, and tighten the fixing bolts.
G
4-2 Attach the Module Holder Clamp
A pipe.
4-3 Attach the DTX to the Module Holder
use the screws included with the Module Holder to attach the
holder to the bottom of the DTX.
4-4 Attach the Module Holder
to the Module Holder Clamp
4-3
Step
Hex Rod Cylinder
H
Tighten
Attach the Module Holder
Left Side Assembly
A
pipe into the Right Side Arm
C
pipe and the Right Side Assembly
A
, and tighten the fixing bolts.
E
, attach the Center Pipe
D
E
Attach the Center Pipe
D
3
Step
Tighten
2
Step
Tighten
1
Step
Right Side Arm
B
Right Side Assembly
C
H into the Module Holder Clamp
G to the Left Side Assembly
F . With a screwdriver,
F (with the DTX attached)
.
G
DTX
Module Holder
F
4-4
Step
4-1
Step
4-2
Step
G
,
B Attach the Drum Pad Clamps
5
5-1 Insert the Hex Rod Cylinders
5-2 Attach the Drum Pad Clamps (Short)
, and tighten
5-3 Insert the Hex Rod Cylinders
6 Attach the Cymbal Holders
6-1 Insert the Cymbal Holders
6-2 Attach the Cymbal Pad to the Cymbal Holders
Drum Pad Clamp
(Long)
Drum Pad
Clamp(short)
After the above assembly is complete, set the Kick Pad, Hi-Hat Con-
trol Pedal, etc. into position and connect the necessary cables. To
keep cable out of the way while playing, use the supplied Cable Bands
to hold the cables to the rack systems's pipes.
, and tighten the fixing bolts.
I J
and floor tom positions.
The Drum Pad Clams (Long)
hat and tom tom positions.
tion of the pad and tighten the fixing bolts.
K
that are attach to the left and right sides of the Center Pipe
, and tighten all fixing bolts.
D
adjust the position and tighten the fixing bolts. (Refer to the
Cymbal Pad's Owner's Manual for instructions on attaching
the cymbal pad to the cymbal holder.)
Step
Cymbal Pad
5-1
Step
Hex Rod Cylinder
H
Cymbal Holder
K
J
I
Step
5-3
Step
H into the Drum Pad Clamps
to the snare drum
I
should be attached to the hi-
J
H in the pads, adjust the posi-
into the Cymbal Holder Clamps
,
K
6-2
Drum Pad Clamp
(Long)
J
Tighten
Cymbal Holder
K
6-1
Step
5-2
Drum Pad
Clamp(short)
I