Connecting The Water Supply Hose; Levelling; Installation And Maintenance; Environment - Samsung WA80HA User Manual

Make use of the User's Manual depending upon your washing machine model.

ENVIRONMENT

Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
•
If the washer is not leveled with the ground, it makes the machine tremble more or be out of order.

LEVELLING

So, make sure that the washer is leveled properly.
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING
THE POSITION OF THE WASHING TUB.
•
Open the lid of the machine, pour water into the tub up to the level
just below the pulsator, and adjust the legs so that the pulsator is
positioned at the center of the water as shown in the figure.
•
Place the machine more than
10cm away from the wall.
•
Adjust the legs on feet
for levelling .
Loosen

CONNECTING THE WATER SUPPLY HOSE

1. Remove the adaptor
from the water supply hose.
2. First,using a "+" type screw
driver, loosen the four screws
on the adaptor. Next,take the
adaptor and turn part(b) fol-
lowing the arrow for gap about
5mm between them.
3. Connect adaptor to the
water tap by tightening the
screws firmly. Then, turn
part (b) following the arrow
and put (a) and (b)together.
4. Connect the water supplyhose
to the adaptor. Pull down the
part (c) of the water supply
hose .When the part (c)is
released, the hose is automati-
cally connected to the adaptor
making a 'click' sound.
Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be
used.
INSTALLATION & MAINTENANCE
The User's Manual is for common use.
Lock
a
b
a
b
c
Never install the washer near water.
Do not place the washer in steamy rooms or where the
washer is directly exposed to rain.Moisture may destroy the
electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected by direct
heat,never place the washer near furnaces, boilers, etc.
Do not place under direct sunlight.
1. Adjust the side horizontally
first and the front
in same direction
2. If the thread is not
within the limit, adjust
the height of
the legs.
5. Connect the other end of the water
5-1.Connect the other end of the water
Screw the hose clockwise all the way in.
If the water tap is a screw type,assemble
a water supply hose that fits to the
tap as shown.
NOTICE After completing connection, if water leaks from the hose,
then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big,remove the spacing
ring before inserting the faucet into the adaptor.
8
next.
supply hose to the inlet water valve
at the back of the washer.
Screw the hose clockwise all the
way in.
supply hose to the inlet water valve
at the top of the washer.