Water Supply Connector Filter; Cleaning The Filter Net; How To Clean The Filter - Samsung WA80HA User Manual

WATER SUPPLY CONNECTOR FILTER

1.Pull out the filter and wash well.

CLEANING THE FILTER NET

1. Push the upper part
of the filter and pull in.

HOW TO CLEAN THE FILTER

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise
until it locks in position.
HOW TO ASSEMBLE THE LEGS
1. Check the 4 Legs.(Front-right. Front-left.
Rear-right. Rear-left)
2. Lay down the Washing Machine to the front.
3. Insert the hook of leg in to the square hole
of base.
4. Push the leg to the arrow direction to "Click".
5. Finaly fix the legs on the base
with screw like a figure.
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
Clean the filter net often to keep the washer clean.
2. Open the cover as
shown in the figure.
inlet water
valve
3. Clean the filter.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the filter-cap to the left.
3.Take the filter out and
remove dirts.
4. Reassemble in
reverse order.
2
10
3. Check if there is a leakage.
Note to tighten up the
connector.
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound .
Hook
Hole
1
Base
Screw