Table of Contents
Advertisement
DJ68-00079P(0.0) 4/23/02 8:54 PM Page 8
RUG/FLOOR SELECTOR
Before use, make sure that the position of the selector button is in the right position for the type of surface to
be cleaned. ❈ In order to maintain best cleaning efficiency, clean floor brush using crevice tool after use.
Push to side ➀ when cleaning
the carpets.
Push to side ➁ when cleaning
the floor, tile, mat, etc.
CYCLONIC FILTER
You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it
maintain the maximum cleaning efficiency.
The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air
and dust revolves in the Cyclonic Filter. So the dust bag contains only smaller ones.
When the Dust Barrel is filled with dust up to the indicating line, it needs disposing and cleaning.
Dust Barrel can be cleaned in water.
1. Turn the Dust Barrel to the left and pull it.
2. Disconnect the Cyclonic Filter from extension wand and handle.
3. Remove thread and hair tangled around the net.
4. After cleaning the Dust Barrel and Cyclonic Filter, connect the Cyclonic Filter with extension
wand and handle(washed part should be dried in the shade throughly before assembling).
5. Push and turn the Dust Barrel to the right.
Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter.
CYCLONIC FILTER
DUST BARREL
TROUBLE SHOOTING
PROBLEM
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind fully.
This Vacuum cleaner is approved the following.
N15490
➀
➁
CREVICE TOOL
CAUSE
No power supply.
Filter, nozzle, suction hose
or tube is blocked.
Check that the cord is not
twisted or wound unevenly.
7
REMEDY
Check cable, plug and socket.
Remove the object.
Pull the cord out 2~3m & push
down the cord rewind button.
DJ68-00079P REV(0.0)
Advertisement
Table of Contents
