Setting The Speaker Mode; Setting The Test Tone - Samsung HT-DS900 Instruction Manual

41P~76P(DS700)-GB-NOR 2004.3.10

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted
according to your speaker configuration and whether certain speakers are used or not.
Press Cursor
In Stop mode,
1 2
button to move to
press MENU
'Audio' and then
button.
press ENTER button.
Press Cursor
In the Speaker
3 4
Setup, press the to the desired
speaker and then
ENTER button again.
press ENTER button.
•
For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL
•
For L and R, the mode is set to SMALL.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note
•
Depending on PRO LOGIC and STEREO, the speaker mode may vary.
53
10:00 AM Page 52
, ,
, buttons to move
NONE.

Setting the Test Tone

Press the Test Tone to check the speaker connections and to adjust the speaker levels.
Press Cursor
In Stop mode,
1 2
button to move to
press MENU
'Audio' and then
button.
press ENTER button.
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
When manually testing using the TEST TONE button
Press TEST TONE button.
•
Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
•
Use this function to check that each speaker is
correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button.
Press Cursor button
3
to move to 'TEST
TONE' and then press
ENTER button.
•
The test tone will be sent to L
R RS LS SW in that order.
If the ENTER button is pressed again
at this time, the test tone will stop.
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)
Multi-Channel Pro Logic Mode
Start
54
C