Dual Screen/Pip/Multi-Pip - Philips FTR9965/17SB Manual

Dual screen / PIP / Multipip
7 8 9
i 0 0
Active Control
q
b h
Changing TV channels or external sources in left, right,
PIP or Multipip screen
+ button or the 0button or the digit buttons in
Press the -
CH
order to change the TV channels or external sources in the
highlighted screen.
Scan , or
PIP 3 PIP 8 PIP 12
Press the cursor down to the lowest PIP to display a following
series of PIP screens.
Press the b button to switch on Dual screen or one of the PIP modes according to
the format selection made in the Dual screen format list in the General menu. See
Settings, General, p. 8.
Press the b button again.The screen that has a yellow border will become the full
0
main screen picture.
Notes:
q
- Continuing to hold the
(Dual screen, Large PIP, Medium PIP, Small PIP, PIP3, PIP8 or PIP12) launching a new format
after each second the button is held down. After standby of the TV, the preference as set in
b
the Settings, General menu is used.
- It is not possible to display a VGA or HD source in a Dual screen/PIP screen.
- When Dual screen mode is selected, two picture formats are supported: Full screen or 4:3
letterbox picture format (vertical squeeze).
- Audio from the right screen or the PIP plays to the headphones.
Display options
Dual screen
- Press the cursor right to highlight the right screen.
- Press the cursor down to highlight the single (large, medium or small) PIP screen.
- Press the cursor right to enter the Multipip screen and then use the cursor buttons
to navigate through the PIP screens and to highlight a PIP screen.
button down will cycle the TV through the various formats
b
PIP
AUX
AUX
Define the position of the single PIP screen
&
Select a Dual screen mode with a single PIP screen.
o
œ
Position
é
Press the cursor down to highlight the PIP screen. A PIP
menu appears with which you can define the position of the
PIP screen.
Note: When the PIP menu is timed out, press the
make it reappear.
"Press the cursor down again to select
'Press the
OK
(Use the cursor buttons to define the position of the PIP
screen.
§Press the
OK
èPress the cursor up twice to highlight the main screen again
and press the
On-Screen information
The highlighted On-Screen information,which appears when
changing channels, always refers to the active screen
PIP 3 PIP 8
PIP1 PIP1 PIP5
PIP2 PIP6
PIP2
PIP3 PIP7
PIP3
PIP4 PIP8
Position
button or the cursor right to activate.
button.The PIP menu reappears.
button to switch off the menu.
OK
PIP 12
PIP1 PIP2 PIP3 PIP4
PIP5 PIP6 PIP7 PIP8
PIP9 PIP10 PIP11 PIP12
button to
OK
.
.
15