Making Connections; Scenario 1: Surround Sound In Zone A Only; Using The Receiver's Speaker B Outputs; Scenario 2: Surround Sound In Zone A And - Kenwood KRF-X7775D Connection And Setup Manual

Chapter Four: Setting Up Multiple Zones
This section describes how to connect speakers in the two
zones to support the different scenarios. Before you read
this section, Kenwood recommends reading "Connecting
Scenario 1: Surround Sound in Zone A only/Stereo in Zone A and Stereo in Zone B (Using the Receiver's Speaker B Outputs)
RECEIVER
A FRONT SPEAKERS B
(6–16 )
Scenario 2: Surround Sound in Zone A and Stereo in Zone B (Using a Stereo Amplifier in Zone B)
RECEIVER
VIDEO R L SUB WOOFER CENTER
ZONE B PRE OUT
DIGITAL OUT COMPONENT VIDEO

Making Connections

Your Speakers" on page 4 of this guide. In addition, this
section discusses how to connect a second TV/Monitor and
how to connect an IR Receiver. (for U.K. and U.S. military)
ZONE A ZONE B
LEFT
SPEAKER
R
L
ZONE A ZONE B
R
Y
LEFT
SPEAKER
The five amplifiers built into the receiver meet your sound
needs for both zones. The built-in amplifiers allow you to
RIGHT
listen to full surround sound if you are listening in Zone A
SPEAKER
only, or stereo in Zone A if both zones are active. You will
always hear stereo in Zone B. Make the speaker connections
as shown in the illustration under "To Connect Front and
Surround Sound Speakers:" on page 5, being sure to also
connect the Zone B speakers to the SPEAKER B binding
post.
You use an additional stereo amplifier for Zone B. This
allows you to listen to full surround sound in Zone A even
if both zones are active. You will always hear stereo in Zone
B. Make the speaker and amplifier connections as shown in
the illustration.
2-CHANNEL
Power Amp
POWER
AMPLIFIER
Both Scenarios: Connecting a Second TV/
Monitor
If you plan to watch movies, or any other visual entertain-
ment activity in Zone B, you must connect an additional
TV/Monitor. To do so, connect a standard composite video
cable from the Zone B TV to the ZONE B PRE OUT VIDEO
jack.
The above is possible only when the composite signals are
input.
RIGHT
SPEAKER
45