Advertisement
Power sources
This unit can be powered with three kinds of supplies including the batteries, household power line and car battery.
When operating the unit with 2 alkaline batteries
1
2
Open the battery cover.
Insert 2 alkaline batteries
and close the cover.
2
1
÷ Make sure the positive (+) and negative (-) poles are properly aligned.
÷ Use commercially available AAA (R03) batteries. The unit may not operate normally if
manganese batteries are used.
÷ Replace both batteries at the same time.
Never use a rechargeable battery and non-re-
chargeable battery together.
Battery duration indicator
Battery Type
Blinking Timing
The duration at which the battery indi-
cator starts to blink is variable depend-
ing on the type of battery used.
Alkaline batteries
When the batteries are half exhausted.
Refer to the table on the right.
Battery indicator
Playback from the first track
Caution: Read this page carefully to ensure safe operation.
2
5
1
3
4
1
Slide the OPEN switch in the direction of the arrow to
open the top cover.
2
Insert disc and close the top cover.
Insert with
labeled side up
Treatment
Playback is possible while the indicator is blinking.
÷ Secure the disc by pushing a position near
the center hole unit it clicks.
To pause playback temporarily
I
÷ When the 6 key is pressed during playback, it pauses
temporarily.
÷ Pressing the key again resumes playback.
Playback from desired track
Skipping tracks
Press the 4 key or ¢ key.
To skip backward
4
¢
÷
¢
When the
key is pressed, playback will skip to the
start of the subsequent track.
÷
Each time the key is pressed, playback will skip to the
next track.
÷
4
When the
key is pressed, playback will skip to the
start of the track being played back.
÷
Each time the key is pressed, playback will skip to the
previous track.
Fast forward, fast reverse
Hold the 4 key or ¢ key pressed during
playback.
Fast reverse
4
¢
÷
Fast forward is engaged by pressing and holding down
¢
key
while playback is in progress.
÷
Fast reverse is engaged by pressing and holding down
4
key
while playback is in progress.
÷
Playback will resume when either key is released.
Connect headphones
3
Set the HOLD switch to OFF.
÷ For the Hold function, read "Hold function".
÷ Before any operation, be sure to set the HOLD
switch to OFF.
E
OFF
When transporting the unit, it is recommended
to set the HOLD switch in advance. In this way
you can prevent unintended operation even
4
when a key is pressed accidentally.
Start playback.
I
Track number
C
÷ The power comes ON and playback begins.
5
Adjust the volume.
÷ With this unit, the BASS BOOST function is
To increase
To decrease
volume
volume
A
÷ Close securely by pushing the front cen-
ter position of the top cover unit it clicks.
To stop playback
To turn power OFF
Total number of tracks
Blinks
H
H
Auto power-OFF function
Total playing time
÷ The total number of tracks and the total playing time of
If no operation key has been pressed for 2 minutes while the
them will be displayed.
unit is in the stop mode, the power is turned OFF automatically
to prevent battery power consumption.
Changing the tone
Repeat playback/Shuffle playback
It is possible to listen to one track or all tracks of
The low frequencies sound, which is felt in head-
a CD repeatedly or to listen to the tracks in ran-
phone, can be boosted.
dom sequence. (SHUFFLE play)
To skip forward
÷ Each press of the REPEAT/
P.MODE key switches the
mode as follows.
G
J
1 One-track repeat
Each press of the key switches the mode as follows:
The track being played
1 Bass Boost OFF
or the selected track will
Normal tone reproduction.
be played repeatedly.
2 All-track repeat
2 Bass Boost ON
All tracks on the disc will
Low frequencies are boosted.
be played repeatedly.
3 Shuffle play
All tracks on the disc will
be played in a random
Hold facility
order.
4 Repeat OFF
Return to normal
playback is made.
The operation keys of the main unit are deacti-
vated. This position prevents undesired operation
÷
After display for about 2 sec, return is made to the original
when the unit is put in a bag, etc.
display.
Fast forward
÷ If a key is pressed just before the end of a
track and the track does not change, press the
J
Notes
Notes
Notes
REPEAT/P.MODE key again when the track
being played back is over.
E
÷ If Shuffle Play is selected while playback is in
progress, Shuffle Play operation will commence
when the track being played back is over.
÷ If Shuffle Play is selected during stop, shuffle
play will start when the PLAY (6) key is
÷ When the HOLD switch
pressed.
÷ Up to 99 tracks can be played back in Shuffle
on the unit is switched
Play operation.
ON, the unit's keys are
÷ The program of tracks is also valid in repeat
protected.
playback.
Programming tracks in desired order
Favorite tracks (max. 24 tracks) can be programmed.
3
1 2
2
2
1
1
Press the REPEAT/P.MODE key for at
least 1 second during Stop status.
÷ Stop status is engaged when the
7 key is pressed while playback
is in progress.
G
Blinks
2
Select the desired track numbers in the
Elapsed time of track be-
order you want to play them.
ing played
1 Select a track...
Track number
set to ON by default. As a result, the audio
4
¢
Blinks
may be distorted if the volume level is too
high in a section dominated by bass sound.
J
In this case, set BASS BOOST to OFF or
decrease the volume.
Programmed order
Light at B.Boost ON
2 and enter it.
G
The following program
sequence will be displayed.
÷ Repeat steps 1 and 2 and enter the Track Nos. into
÷ After stopping playback, press
the program in order.
the 7 key again.
÷ When 24 tracks have been programmed, "FULL" will be
displayed.
3
Start playback.
I
Connections
Notes:
Listening through
÷
Adjust the listening volume on the
speakers
connected audio component.
÷
The LINE OUT volume can be
(Speakers
with built-in
adjusted using the main unit's
amplifier)
VOL. keys as well as using the
F
remote's VOL. keys. The level
recommends 25.
÷
Make sure to switch Bass Boost
off. (The tone should be adjusted
only on the connected audio com-
Light at B.Boost ON
ponent.)
ON
÷ When the HOLD switch
on the remote control is
switched ON, the unit's
keys are protected.
To change the programmed contents
To check the programmed contents
1
1
Press the REPEAT/P.MODE key for at
Press the REPEAT/P.MODE key for at
least 1 second during Stop status.
least 1 second during Stop status.
÷ Stop status is engaged when the
÷ Stop status is engaged when the
7 key is pressed while playback
7 key is pressed while playback
G
is in progress.
G
is in progress.
2
Press the REPEAT/P.MODE key.
2
Call the programmed order to be changed.
Track number
Blinks
÷ Press the REPEAT/P.MODE key
G
repeatedly until the programmed
order you want to change is dis-
G
Programmed order
played.
÷ The programmed track numbers will be displayed in sequence
Track number
each time the REPEAT/P.MODE key is pressed.
Blinks
To clear the programmed contents
Programmed order
Press the 7 key
3
H
during Stop status.
Enter the Track No. you want to change.
÷ The "PGM" indicator is turned off when the program is
1 Select a track...
cleared.
÷ Program mode can be canceled even if the top cover is
4
¢
open.
J
Control tone (beep) setting
2 and enter it.
The control tone generated when a key is pressed
can be muted as follows. This operation should
be performed in play or stop mode.
1
G
Press and hold the B.BOOST key for more
than 2 seconds.
2
While "bP on" is displayed, press the 4
When the programmed contents are to be changed further,
repeat steps 2 and 3 .
or ¢ key.
Listening through an
amplifier with CD input jack
Amplifer
÷ Connect the cable to
the amplifier's CD input
jacks.
÷ This connection may
be impossible with
some amplifiers.
Ò
DPC-X527 (EN-M)
Advertisement
