Table of Contents
Advertisement
Menu system
Function of KDC-MP4036AX
In Standby mode
Security Code
Activating the Security Code disables the usage
of audio unit by someone else. Once the Security
Code is activated, the entry of authorized Security
Code is required to turn on the audio unit when it is
removed from the vehicle. Indication of this Security
Code activation prevents your precious audio unit
from stealing.
⁄
• When you activate the Security Code function, it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Menu mode
Press the [MENU] button for at least 1 second.
When "MENU" is displayed, "CODE SET" is displayed.
3
Enter Security Code mode
Press the Control knob for at least 1 second.
When "ENTER" is displayed, "CODE" is also
displayed.
4
Select the digits to enter
Push the Control knob towards [4] or [¢].
5
Select the Security Code numbers
Push the Control knob towards [FM] or [AM].
6
Repeat steps 4 and 5, and complete the
Security Code.
7
Confirm the Security Code
Press the Control knob for at least 3 seconds.
When "RE-ENTER" is displayed, "CODE" is also
displayed.
8
Do the step 4 through 7 step operation, and
reenter the security code.
"APPROVED" is displayed.
The Security Code function activates.
⁄
• If you enter a Code different from your Security Code,
you have to start over from step 4.
16
|
English
Resetting the Security Code function when the
audio unit is first used after removed from the
battery power source or the Reset button is
pressed
1
Turn the power ON.
2
Do the step 4 through 7 step operation, and
reenter the security code.
"APPROVED" is displayed.
Now, you can use the unit.
⁄
• If an incorrect code is entered, "WAITING" is displayed,
and the input prohibition periods shown in the table
below is generated.
After the input prohibition time lapses, "CODE" is
displayed, and you can reenter the code.
Number of times the
incorrect code was input
1
2
3
4
In Standby mode
Touch Sensor Tone
Setting the operation check sound (beep sound)
ON/OFF.
Display
Setting
"BEEP ON"
Beep is heard.
"BEEP OFF"
Beep canceled.
Input prohibited time
—
5 minutes
1 hour
24 hours
Advertisement
Table of Contents
