Audio Setup - Mitsubishi MZ360119EX(DPXMP2090SM4 Instruction Manual

Bass level
Adjustment Item Display
Bass Center Frequency "BAS F"
Bass Q Factor "BAS Q"
Bass Extend "B EX"
Middle level
Adjustment Item Display
Middle Center Frequency "MID F"
Middle Q Factor "MID Q"
Treble level
Adjustment Item Display
Treble Center Frequency "TRE"
5
Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [VOL] and the [ATT]
buttons.

Audio Setup

Range
Setting the Sound system, such as Cross over
40/50/60/70/80/100/
Network.
120/150 Hz
1.00/1.25/1.50/2.00
1
OFF/ON
2
Range
0.5/1.0/1.5/2.0 kHz 3
1.0/2.0
Range
10.0/12.5/15.0/17.5 kHz
4
5
Select the source to adjust
Press the [SRC] button.
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Front High Pass Filter "HPF"
Rear High Pass Filter "HPR"
1,2
Low Pass Filter* "LPF"
1,2,3
Subwoofer Phase* "PHAS"
Volume offset "V-OFF"
Loudness "LOUD"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
1
• * You can control this item when <Switching preout>
(page 21) is set to "SWPRE SW".
2
• * You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
• * 3 You can control this item when Low pass filter is not
set to Through.
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/
Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0
OFF/ON
9
|
English