AT&T E2520 Quick Start Manual page 2

E2520 QSG.qxd 07/19/2004 3:21 PM Page 2
Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the batteries to charge for 8 hours before use. You can
keep the batteries charged by returning the handset to the base after each use.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
To replace battery cover
Insert top
tab first.
Caution: Use only the supplied NiCd battery or
AT&T model 2AA NiMH replacement battery
(SKU 26820). Do not use alkaline batteries.
Insert supplied
batteries.
Press down to
click in place.
Plug power cord
transformer into
electrical outlet.
Route cords through
slot in base.
Place handset in base to charge
for 8 hours before first use.
Rotate antenna to fully upright
position.
Plug long tele-
phone line cord
into telephone jack.