Advertisement
Installation and setup
1.
Plug one end of the telephone line cord
into the telephone jack at the bottom of
the telephone base.
6.
Plug the small end
of the smaller power
adapter into the jack
on the underside of
the charger, then route
the cord through the
slot as shown.
7.
Plug the large end
of the smaller power
adapter into an electri-
cal outlet not control-
led by a wall switch.
TONE
REDIAL
MUTE
INT
DELETE
PAUSE
8.
You may be able to
make and receive short
calls. For best perform-
ance, place the hand-
set in the telephone
base or charger to
charge for at lease 16
hours before first use.
2.
the power jack at the bottom of the telephone
base.
5.
Plug the other end
of the telephone line
cord into a telephone
jack.
Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section, below.)
NOTES:
1. Use only the power cord supplied with this product. To
order a replacement power cord, visit our website
at www.telephones.att.com, or call 1 (800) 222-3111; in
Canada, call 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall
switch.
3. This power unit is intended to be correctly oriented in
a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
4. If you receive high speed internet through your telephone
line (commonly referred to as DSL), and you are experienc-
ing interference during telephone conversations and/or
your caller ID features are not functioning properly, install
a DSL filter to the telephone line between the telephone
base and the telephone wall jack. Contact your DSL serv-
ice provider for a DSL filter.
Plug the small end of the power adapter into
3.
Route cords
through slots.
4.
Plug the large
end of the larger
power adapter into
an electrical outlet
not controlled by a
wall switch.
Advertisement
