Bluetooth-enabled in-dash dvd/mp3/cd receiver with 3.6-inch widescreen tft monitor with usb and sd memory card ports and front panel aux input (25 pages)
Page 1
SD MEMORY CARD PORT AND FRONT PANEL AV INPUT 12.2011 BOSS Audio Systems 3451 Lunar Court • Oxnard, CA 93030 www.bossaudio.com iPod® is a trademark of Apple, Inc. registered in the U.S. and other countries. 800.999.1236 Boss Audio Systems is not affiliated with Apple, Inc. tech support: www.bossaudio.com/support...
Page 2
PRECAUTION WARNING: TO REDUCE THE CAUTION RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE RISK OF ELECTRIC SHOCK THIS APPLIANCE TO RAIN OR DO NOT OPEN MOISTURE. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Contents 1. Before Operation...................3 1.1 Glossary....................3 1.2 Precautions....................3 1.3 Maintenance and Cleaning of Discs............4 1.4 Battery Information of the Remote Control..........4 1.5 The Remote Control Description..............5 1.6 Locations and Names of the Controls............6 1.7 Description of the Rear Cabinet...............7 1.8 Unit Installation..................8 2.
1. Before Operation 1.1 Glossary PBC (playback control) It is a kind of signal(menu) recorded in the disc with SVCD or VCD2.0 format used for the playback control. For the discs contained PBC, It can playback interactive software with the menu displayed on TV. Title Generally, the title is the important part of DVD disc.
1.3 Maintenance and Cleaning of Discs 6. Specification Disc Maintenance 1. To keep the disc clean, andle the disc by its edge, do not touch the disc General Specification surface of the play side. 2. Do not stick paper or tape on the disc. If there is glue (or analog) on the Power Supply Requirement..........DC 12V disc surface, must wipe it up before using.
1.5 The Remote Control Description 5. The Trouble Shooting 1. P/N BUTTON Please read the user s manual carefully before using the DVD player. If you have any troubles in using this player, try to solve the problems by the suggestions mentioned below. If you can 2.
1.6 Locations and Names of the Controls 15 16 4.28 The Region Code Q: Not begin to playback but to display REGION ERROR after inserting disc into BV7942 disc compartment. Why ? A: Because the DVD player and disc has respective region code. If the region codes of them are not match with each other, the DVD player can not play the disc.
1.7 Description of the Rear Cabinet 4.27 The Parental Control GREEN GREY SUBWOOFER RED R RED R Q:After inserting DVD disc into disc compartment, it will appear a dialogue window GREY BLACK that ask me input a password of 4 digit. Why ? REAR RCA LINE OUT FRONT RCA LINE OUT Fixing Screw Bolt...
1.8 UNIT INSTALLATION INSTALLATION INSTRUCTIO NS It is for adjusting the hue of the video output. THE UNIT INSTALLATION IS ANTI-THEFT ONE. THE UNIT CHASSIS WEARS A SLIDING METAL HOUSING. SATURATION FIRSTLY CONNECT THE POWER LINES, SPEAKER LINES AND AUTO ANTENNA ACCORDING TO MANUAL REQUIREMENT, THEN INSTALL THE SLIDING METAL HOUSING IN A CAR ACCORDING TO THE DIAGRAM.
2. Common Operation 4.26 .2 LANGUAGE SETUP 1. To turn on/off the unit Under power off mode, press the POWER button to turn on the unit. LANGUAGE SETUP Under power on mode, long press the POWER button on the front panel or OSD LANGUAGE briefly press the POWER button on the remote controller to turn off the unit.
Page 11
10.To adjust the sound equalizer curves To adjust the sound equalizer curves, briefly and repeatedly press the SEL For the DVD System Menu, there are 6 setup pages in all. They display as follows: button to select the sound equalizer curves of VOL, BAS(without preset EQ), TRE (without preset EQ), BAL, FAD, then rotate the VOL knob on the front 4.26.1 SYSTEM SETUP panel or press the + or - button to adjust level.
3. During JPEG playback, press one of the >/</^/v buttons to change the angle of viewing picture that is displaying as follows: >: 90 deg cw; <: 90deg ccw; ^:UP<-->DOWN; v: LEFT<-->RIGHT 3. Radio Operation During JPEG playback, press the PROG button to change the mode of refresh picture. During JPEG playback, press the STOP button to stop playing and return to the root menu.
Page 13
4.21 Program Playback 7. PTY (PROGRAM TYPE) BUTTON Press the PTY button shortly to select one of the following mode: It allows you to enter the order in which you want some chapters/tracks in PTY MUSIC group- - PTY SPEECH group- - PTY OFF DVD/VCD/MP3/WMA/CD disc to play.
ZOOMx2,ZOOMx3,ZOOMx4,ZOOMx1/2,ZOOMx1/3,ZOOMx1/4,ZOOM OFF. 4. Basic Disc, USB or MMC/SD Operation Press one of the ^/v/>/< buttons to select the area you want to enlarge. 4.1 Begin playback 4.17 Change the Caption Language 1. Press the POWER button briefly to turn on the DVD player. In the state of DVD disc playing, press the SUBTITLE button repeatedly to After turning on the DVD player, please turn on the monitor, and ensure that select the language of the caption or turn off the caption.(depend on the...
4.12Playback in Scan Mode 4.2 Pause Playback 1. In the state of VCD(PBC OFF)/CD disc playing, press the INT button to play In the state of DVD/VCD/CD/MP3/WMA disc playing, press the PAUSE the previous 15 seconds part of each track on the disc. Press the INT button button on IR remote controller to pause the playback, press the PLAY again to resume normal playback.
During slow forward, press the PLAY button to resume normal playback. In VCD mode The function is only for video. 1. When starting to turn on the PBC function, it will play from the beginning of the disc till it display the PBC menu on TV screen if the disc include the PBC menu.
Need help?
Do you have a question about the BV7942 and is the answer not in the manual?
Questions and answers