Dell PowerEdge 6350 User Manual page 49

9. Select NetWare 4.11 as the product to install and press <Enter>.
10. Press <F1> to view detailed explanations of the installation and upgrade options,
select between a simple or custom installation, and press <Enter>.
11. When prompted, type a name for the server and press <Enter>.
12. When prompted to install IntranetWare symmetric multiprocessing (SMP), select
No and press <Enter>.
NOTE: Even if you plan to install IntranetWare SMP , select No at this screen. The
IntranetWare Support Pack 4 or later must be applied before IntranetWare SMP
can be installed. To apply IntranetWare Support Pack 5, see "Installing the Dell-
Supplied Novell Patches and Support Pack 5" found later in this section.
The system searches for existing device drivers and hardware.
13. Press <F3> to continue through the next few screens until the Choose the
Server Drivers screen appears.
14. Select Select/Edit Disk or LAN drivers and press <Enter>.
15. Select Disk and CD-ROM Drivers as the type of driver to install and press
<Enter>. A list of installed drivers appears.
NOTE: Do not use the SCSI driver for the AIC-7860 host adapter that appears in
the list of installed drivers.
16. Press <Insert> to install an unlisted driver.
17 . Insert the backup copy of the IntranetWare 4.11 SCSI and RAID driver diskette
into the diskette drive and press <Enter> to continue. A list of drivers on the dis-
kette appears.
NOTE: If you have not already created this diskette, refer to the Dell Server Assis-
tant CD.
18. Select the aic78u2.ham driver and press <Enter>. The driver is copied to the
hard-disk drive.
NOTES: Specific help text for each driver appears in the middle of the screen as
you scroll down the list. The Loaded Drivers window below the list of available
drivers displays the names of drivers that are loaded and operational. For a new
installation, this list is initially empty. For a selective installation, the list shows
the drivers already running.
If you have two controllers that use the same driver, such as two Adaptec
AIC-7890 host adapters, you must load the same driver twice—once for each
controller.
19. At the Save existing file Y/N prompt, type Y or N as necessary and press
<Enter>.
Installing and Configuring SCSI Drivers 3-17