Advertisement
7(b) Install and tighten allen set screw with 1/8 allen
wrench (see Fig. 8).
7(c ) Slide threaded collar onto shock. It should
seat against snap ring. Front shocks are
easily identified by short threads on the piston
rod (see Fig. 9).
The rears have long threads on Piston rod
(see Fig. 10).
Fig. 8
Fig. 9
Fig. 10
Step 8 Assembly of Front shocks
8(a) Insert coil spring with flat ground end against
threaded collar seat .
8(b) Put shock and coil spring in spring
compressor (see Fig. 11).
8(c) Compress coil spring until lower seat has
enough clearance to install lower seat and
9/16 jamb nut (see Fig. 12).
Fig. 11
Fig. 12
Advertisement
