Dell PowerEdge 350 Hardware Installation page 5

support.dell.com


    
 
The information in this document applies to systems with either an 850-megahertz
®
(MHz) or higher Intel Pentium
microprocessor.

          
 
When replacing or installing a memory module in the DIMM3 socket on your system
board, you must first remove the heat sink from the microprocessor.

   
To remove heat sink, perform the following steps.

          
             
     ! " "    #  
   
   
$%&%      '(  )  *  (
         +*     *
+   
$%&
 *(      ' +*' 
  ,   (    ' 
&%-  .  ((-*  / ( #  
    
     
1. Release the clip securing the heat sink to the microprocessor socket by pressing
on the heat sink clip tab, and then releasing the clip from the opposite side of the
socket.
2. Lift the heat sink away from the microprocessor.
®
microprocessor or a 700-MHz or higher Celeron™
Information Update 1-1