Dell PowerEdge 2900 Information Update page 12

Table 1-1. System Messages (continued)
Message
PCIe Degraded Link
Width Error: Slot n
Expected Link
Width is n
Actual Link
Width is n
PCIe Training
Error: Embedded
device
PCIe Training
Error: Integrated
device
PCIe Training
Error: Slot n
Remote Access
Controller cable
error or incorrect
card in the RAC
slot.
NOTE:
All TPM information messages appear after the BMC option ROM has been
loaded during POST.
12
Information Update
Causes
Faulty or improperly
installed PCIe card in
the specified slot.
Faulty system board
or riser board.
The specified PCIe device
is faulty or improperly
installed.
Faulty or improperly
installed PCIe card
in the specified slot.
RAC cables not connected,
or RAC card installed in
wrong expansion slot.
Corrective Actions
Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" in the
Hardware Owner's Manual.
If the problem persists,
see "Getting Help" in the
Hardware Owner's Manual.
See "Getting Help" in the
Hardware Owner's Manual.
For a SAS controller
daughter card, reseat the
card in the dedicated PCIe
connector. See "Installing a
SAS Controller Daughter
Card" in the Hardware
Owner's Manual. If the
problem persists, see
"Getting Help" in the
Hardware Owner's Manual.
Reseat the PCIe card in the
specified slot number. See
"Expansion Cards" in the
Hardware Owner's Manual.
If the problem persists,
see "Getting Help" in the
Hardware Owner's Manual.
Check that the RAC cables
are connected, and that the
RAC card is installed in the
correct expansion slot.
See "Installing a RAC Card"
in the Hardware Owner's
Manual.