Operating Your French Door Refrigerator; Using The Control Panel - Samsung RF4287HABP User Manual

Operating your French Door Refrigerator

uSing tHE contRoL PAnEL

( 1 ) Energy Saver
Press the Energy Saver button for better energy efficiency.
The Energy Saver icon lights up when you press the Energy Saver button.
The Energy Saver function is automatically set to "ON" when power is supplied to the refrigerator.
If condensation or water drops appear on the doors, turn the Energy Saver mode off.
The Power Freeze function substantially speeds up the freezer compressor, causing the freezer to cool down
( 2 ) Power Freeze
rapidly to a temperature you choose. When you press the Power Freeze button, the Power Freeze icon lights
up.
Power Freeze is useful if you need to quick freeze an item, to make a large quantity of ice, or to cool the
freezer rapidly if it has warmed dramatically (for example, if the door was left open).
To turn off Power Freeze, press the Power Freeze button again. Power Freeze turns off automatically after 2
1/2 hours to decrease energy consumption.
Cooling Off mode (also called Shop mode), is designed for use by retailers when they are displaying
Cooling Off Mode
refrigerators on the shop floor. In Cooling Off mode, the refrigerator's fan motor and lights work normally, but
the compressors do not run, and the refrigerator and freezer do not get cold.
To start Cooling Off mode, press and hold the Energy Saver button and the Power Freeze button for 3
seconds during normal operation. The refrigerator chime sounds and the temperature display flashes OF OF.
To cancel Cooling Off mode, press and hold the Energy Saver and the Power Freeze buttons again for 3
seconds.
( 3 ) A larm / hold 3
The Alarm/Hold 3 sec for Filter Reset button serves two purposes:
- To turn the door open alarm on and off
sec for Filter
- To reset the water filter life indicator.
reset
1) Door Alarm Function
If the door alarm is set to On, an alarm beeps if any refrigerator door is left open for more than three
(Filter Reset)
minutes.
The beeping stops when you close the door. The door alarm function is pre-set to On in the factory. You
can turn it off by pressing and then releasing the Alarm/Hold button. You can turn it back on in the same
(Blue) (Red)
fashion. The icon lights up when the function is on.
2) Water Filter Life Indicator Function
After you replace the water filter, press and hold the Alarm/Hold 3 sec for Filter Reset button to re-set the
water filter life indicator. When you re-set the water filter life indicator, the Filter icon on the panel turns
blue, green, or yellow.
The Filter icon will turn red to let you know it is time to change the water filter after six months (about 300
gallons).
1
2
3
Some areas have large amounts of lime in their water, which causes the water filter to clog
more quickly. if this is the case in your area, you will have to change the filter more frequently
than every six months.
Operating _23