Page 1
MODEL HBF80G BAR CHILLER OPERATING INSTRUCTIONS The manufacturer keeps on developing various types of refrigerators, so he has the right to modify designs, products and technical data without further notice.
Page 2
FIGURATION OF THE BAR CHILLER =Ice-tray Thermostat with defrost button Evaporator ========== Shelf Drip tray...
Page 3
NOTICE Never store anything dangerous The power supply in the appliance, such as for appliance is combustibles, exposives, 240V, 50Hz single phase. strong acid and alkali. etc. It is not The appliance is not intended recomended for use by young children or to use any infirm persons without extension cords.
THERMOSTAT The knob graduation 0, 1, 2, 3, 4, 5, 6, 7, does not stand for concrete temperature.The smaller the numbers,the higher the temperature in the compartment and vice versa.Usually,it’s better to put the thermostat in Pos. “1”,Pos. “4”, Pos. “0” shows the power is cut off.
NOTES ON STORAGE Where necessary, food should be packed in bags, avoiding giving off strong odours or getting wet or dry. Do not store food too full in the appliance. Allow space among the packages of food for a perfect refrigerating. Hot food or liquid must be allowed to cool to room temperature before placing in it.
Page 6
DEFROSTING To defrost,remove the food and ice cube fray from the freezer section. Make sure the drip tray is under the freezer section and push the defrost button on thethermostat.Defrosting 4~6mm may take a few hours.When defrosting process has been completed,the drip-tray should be depletde.Replace the food and switch on the appliance.
Page 7
In the event of a fault occurring during operation, check first if the fault is due to an operation error. You can repair the following faults yourself. 1. It is not switched on properly, or mains plug properly inserted The appliance does in the socket.
LEFT/RIGHT-OPENED DOOR This product is assembled according to the right-opened door configuration. The right hinge together with its mount is fixed on the right side of the door body. Take out the door handle from the accessory parts and fix it on the left side of the door body. The two holes on the right side of the door body shall be stuffed with the handle hole stoppers, as an item of accessory parts.